APT30A
APT30A rising bollard
The APT30A is a highly versatile and slim automatically rising PAS68 bollard that has been fully tested at TRL with the N2 7.5 ton vehicle travelling at 48kph. This was tested as a single unit with a single foundation and is supplied complete with integral re-bar pre attached to the bollard making installation very easy.

The APT30A will protect any key facility from a vehicular based attack.

Features include:


- Manufactured by Eagle Automation in the UK
- Impact tested as a single unit in a single foundation
- Supplied with integral re-bar making installation simple and quick
- Slim 219mm diameter bollard when painted or when in stainless steel
- 1000mm raise height above ground
- Painted, stainless steel or bespoke finish
- Stainless steel sleeve can be designed to your specific requirements
- Zero penetration after impact
- Uses 3 phase power at 10amp
- 100% duty cycle
- Raises and lowers in circa 6-8 seconds
- Can be supplied with LPS SR2 or LPS SR4 security cabinets if required
- Complies with all safety standards
- Supplied with a high performance control board
- Works standalone, in unison with other products or as a tiger trap
- Can also be used as a manual system via drill or hand-pump
- V7500(N2) 48/90:0/0
Head Office
Unit 5, New House Farm, Vicarage Lane, North Weald, Essex, CM16 6AP, UK.
+44 (0)1992 524 800
Oxforshire / Buckinghamshire
6 Beech Road, Princes Risborough, Buckinghamshire, HP27 0BP, UK.
+44 (0)1992 524 800
© Eagle Automation Ltd 2018
Brilliant website creators